Hello folks! Today I want to show you a new restoration project. I found this big axe at a flea market. It looked unusual; the seller said it butcher an axe. The weight is large. In addition to the unusual shape, the hole is also not round. In a word, I haven't seen such an axe yet! Let's start the restoration.
0:00 Review
0:18 Rust remover
0:34 Wash-dry-oil
1:03 Wire cup brush
1:20 Electrolysis
2:09 Correction
2:53 Sanding
3:13 Axe bevels
3:43 Axe handle holes
4:22 Handle
6:28 Gluing
7:02 Handle processing
7:30 Sharpening
7:58 Axe sheath
10:30 Final review
11:00 Test
As usual, I used rust remover liquid, then washed and oiled. After, I used a circular wire brush, but I didn't like the result. There's a lot of old rust left. Then I used electrolysis to clean the surface of the axe. After I washed it and started correcting the shape. Next, I started sanding the axe. I used sandpaper from 40 to 400 grit. Then I made new bevels for axe. For handle I chose oak tree and brass pins. I hope, you will enjoy this restoration project. Next, I sharpened the axe and made a test for you. Thank you for watching!
Recipe of the dish:
Beef meat. As soon as the water boils, be sure to remove the foam! Otherwise, spoil the taste of the broth. Do not peel onions, carrots, black pepper with peas, bay leaf.
Add garlic and herbs to taste.
Sincerely, Alex. Thanks for attention!
Good luck and health to everyone! With best wishes, Alex!
Please subscribe to my channel: @ScrewsAndTools
🍖 My New Cooking channel! @screwsandtoolscooking
Patreon: / screwsandtools
Paypal: paypal.me/screwsandtools
Facebook: / scresandtools
Instagram: / screwsandtools
#screwsandtools #axe #restoration
Негізгі бет Тәжірибелік нұсқаулар және стиль Restoration Old Rusty Butcher Axe
Пікірлер: 221