Big thank you to Share your knowledge🙏🏻🙏🏻. Very very clear explanations about BimmErCode 🤙🏻. Do you have same vidéo And CODDING lines for revers caméra please ?☺️☺️😉🙏🏻 i have all OEM components to install it on my f20 2012 cic. 😉
@lorsamadey2435
2 жыл бұрын
I don't get it.. So every bmw has heated steering wheel all you have to do buy a trim with button and code it ? 😐😐
@WhiteRoseDrives
2 жыл бұрын
Not every one, no. See the original thread on Bimmerpost, linked here in the description. If it has lane departure warning, then it most likely has the heating element and electronics. Keeps manufacturing simpler eh?
@lorsamadey2435
2 жыл бұрын
@@WhiteRoseDrives i have line assist, so thank you and thanks to the video owner 😁👍
@alanjohnston3648
2 жыл бұрын
Defos doing this as I have the innovation pack on my F30 335d X Drive shadow .
@WhiteRoseDrives
2 жыл бұрын
Do let us know how it goes Alan!
@danfullstop
7 ай бұрын
Thanks for the video, although I didn’t need to remove the steering wheel myself to do it, it was good to see the whole process to understand it fully before tackling it myself, cheers 👍
@Mike-wp4el
8 ай бұрын
Thanks. Where are you based? I have an Tiger supercat if you fancy a drive out sometime?
@harrisnabil
5 ай бұрын
Hi not too sure how clued up you are about this but ive done the coding for my F20 M140i and for some reason whenever im starting the car up it says “battery discharge whilst station” is it possible ive got wrong somewhere with the coding? It works perfectly as well
@WhiteRoseDrives
5 ай бұрын
TBH, not that clued up 😂 I was lucky in that I just followed the forum post, and everything worked as expected. If you’re having issues I really recommend dropping in on the Bimmerpost thread - there are lots of experienced folks there who may be able to offer advice and pointers 😃
@hb1778
9 ай бұрын
Can you still get this if you don’t have lane departure?
@子集魏
2 жыл бұрын
Hi mate!Thanks for your video, its relly helped me! I would to buy this trim my self, could you please tell me where you bought it? Do you know the part number of this trim. Thanks!
@WhiteRoseDrives
2 жыл бұрын
Would you believe, the cheapest place I found for the trim + switch was my local BMW dealer here in the UK. The parts were available from lots of folks on ebay too though, so always worth looking there 👍
@子集魏
2 жыл бұрын
@@WhiteRoseDrives thank you!I’ll go and check!
@WhiteRoseDrives
2 жыл бұрын
Forgot to mention the part numbers - sorry. Check the original bimmerpost article (linked in description) for the two part numbers you need 👍
@WhiteRoseDrives
2 жыл бұрын
Hello! I've just stumbled across the two part numbers anyway - 61316823468 (cowling) and 61319201736 (button) 👍
@子集魏
2 жыл бұрын
@@WhiteRoseDrives hello, thanks for your information! I already did the retrofit with your guidance , everything works well, thank you!
@ethanwild3301
Жыл бұрын
0:05 rain nods?
@ethanwild3301
Жыл бұрын
"In Raynaud's phenomenon, smaller arteries that supply blood to the skin constrict excessively in response to cold, limiting blood supply to the affected area."
@MrKnucklez1000
Жыл бұрын
Is this possible if there is no lane assist module? Or is it possible to get the bottom unit with the button + a heated steering wheel. A friend has a spare one laying around.
@WhiteRoseDrives
Жыл бұрын
To be honest, I don’t know. Check the thread on Bimmerpost? You can also look in the wheel - the module and heater elements are visible. That’s discussed in the Bimmerpost thread too 👍
@omerfaikkayhan2325
2 жыл бұрын
Hi first of all many thanks to you secondly have you changed your bottom piece of your wheel for put the heat button ?
@WhiteRoseDrives
2 жыл бұрын
Hello! No, the wheel is what was already there. If you have lane change warning you probably already have the heating elements. You can tell by looking for wires going down the bottom “arm”. Follow the link in the description to the original bimmerpost article 👍
@Shorepower
Жыл бұрын
THANK YOU for the guide with bimmercode! Cowling was fairly easy to remove withouth detaching the steering wheel.
@Mike-wp4el
8 ай бұрын
How did you remove the cowling without removing the steering wheel?
@Shorepower
8 ай бұрын
Cannot remember anymore, but I think I did remove the steering wheel
@danfullstop
7 ай бұрын
@@Mike-wp4el pull hard directly from the back of the cowling with the wheel at the highest and farthest out setting, took me a couple of attempts but it came off fine with the wheel in place.
@Rimlax123
2 жыл бұрын
First of all, You need to have a steering wheel with heating element and also heating ecu for that. Also SZL if will be stock, it does not have extra connection for that ecu. Weird, that these things are not mentioned..
@WhiteRoseDrives
2 жыл бұрын
Check the description for the original forum thread, where the prerequisites are discussed 👍
@Oockeshoek
2 жыл бұрын
What is the heating ECU according to you? If I buy heated wheel, cowl + SZL will it not work? I'm looking to buy a new SZL anyway when retrofitting KAFAS2 in the future
@Rimlax123
2 жыл бұрын
@@Oockeshoek SZL needs to have contact in it for heated and/or vibro steering wheel. I retrofitted myself KAFAS2 and vibro steering wheel in one go. KAFAS2 and SZL does have anything in common.
@Oockeshoek
2 жыл бұрын
@@Rimlax123 okay so if I get SZL (vibro or heated) + Vibro/heated wheel I can have heated wheel right? Then I add KAFAS2 in future with all cables etc. I can activate lane departure.
@Rimlax123
2 жыл бұрын
@@Oockeshoek Yes, but I also find another issue when installed mine. I used my previous wheel, just put into it vibro wheel and ecu for it. My steering wheel does not cable for power supply to vibro ecu, so I need to order new wires and install it into the wheel. It was prety similar as old one, just had one extra cable for vibro ecu. But If You arleady pick wheel which has vibro or heated function then You will not catch this problem.
@ASSK555
2 жыл бұрын
There’s no need to remove the steering wheel. You can just remove the housing with brut force. The housing isn’t connected to the steering wheel. I’ve also made the cable myself, 3 wires are needed, a dupont set is a must.
@WhiteRoseDrives
2 жыл бұрын
Somebody did comment on the bimmerpost thread that they managed to get the cowling off without removing the wheel too. Thanks for letting viewers know 👏 👍
@ASSK555
2 жыл бұрын
@@WhiteRoseDrives thank you for the great video btw and sourcing the code. Helped me a lot.
@andritmarku2960
Жыл бұрын
you are right i was watching the video i was thinking why 😁. it makes no sense removing the wheel.
Пікірлер: 42