With the crimping of the wires, I find it easier to put the connector in the tool first and start the crimp so it just holds the connection. Then put the wire in and crimp away.
@dennisharold8934
Looks great!
@hyne1972
Looks very neat and tidy indeed. You are definitely the man to have a look at my new B7 project, car is built just needs Electrics installed 👍🏼
@InstrumentvanVrede
21 күн бұрын
This b74 looks like my 22x-4
@jim52970
Ever weigh the total wire you've cut-off? Curious how much weight was saved with your wiring "clean-up".
@tomvc1292
Nicely done. Any change on a link to the pins kit you used hopefully it's
@remkojerphanion4686
Nice!
@allscalerc
I'm about to build one so this is really helpful. Thank you and I just subscribed to your channel. 👍👍👍👍👍👍
@MysticRiverRC
Cable management for the win! Bravo! new sub!
@blameusa7082
something to do when the wife is having one of those days.
@SeanyRC
When are you going to get that 1/8 Agama out!
@silverfox9307
Really neat, do you have a link to the crimping kit?
@Epsonblade
Could you specify the crimping tool you use for those pins you are putting on? I have the set and normally just use my tiny pliers and crimp them all individually but I have been after the right tool for some time.
@alantaylor353
But, But... where's the black tape, multicoloured zipties & elastic bands.?
@FarmerFpv
I don't use wires or solder. I connect my Motor, ESC, Servo, and Receiver via Bluetooth. It has that Pro Platinum look.
@InstrumentvanVrede
21 күн бұрын
I guess your customer is too lazy to do this himself.
Пікірлер: 29