GOOD SIR , IT IS HELPFUL FOR ME , I PRAY TO GOD FOR YOUR SUCCESS.
@switchon7938
8 ай бұрын
Thank you so much 🙏
@devkaransingh6614
Жыл бұрын
Sir your vedio is too good, it could best if Voice should be there with vedio, please look into this😊
@switchon7938
Жыл бұрын
SURE MY DEAR FRIEND
@rafaelbenaia6584
7 ай бұрын
Hello sir, That was a great video! I need to configure the relay function keys, but the function key tab is blank. How can I do this?
@BMKinfinity32
Жыл бұрын
How to reset from scada sir bo9 is for what if all led need to assign in user bo9
@manikandan-oy1rx
Жыл бұрын
its output command from scada to reset 86 and all led's
@switchon7938
Жыл бұрын
You have to assign a single point output command spdoes to bo9 which I am not shown in this video
@BMKinfinity32
Жыл бұрын
Sir how to make this setting in pdf or cxcel export option
@BMKinfinity32
Жыл бұрын
Fir printing
@sirajpasha4618
10 ай бұрын
how to name BI & BO? when we see in disturbance record
@switchon7938
10 ай бұрын
For that you have to change the name in input and output matrix
@sirajpasha4618
10 ай бұрын
@@switchon7938 where pl tell
@sirajpasha4618
10 ай бұрын
also how to send this file to relay pl tell
@switchon7938
10 ай бұрын
First save the file and near to that save icon you have send option
@sirajpasha4618
10 ай бұрын
@@switchon7938 we are creating this project file in offline without connecting the relay. if we want to extract the existing project file & make change in that & send back to relay then how to do pl tell.
@switchon7938
10 ай бұрын
1.use reydisp evolution software connect the relay with serial port 2.in thesoftware page left side down you found connected device 3.just click it ,once it connected then click the download settings 4.after download ,configure it after complete your configuration click save and click update setting then send the file by clicking upward arrow icon on the top of your page . @@sirajpasha4618
Пікірлер: 18