In this tutorial you'll get practice creating some of the geometry types used in Rhino. These are the basic elements you’ll use to build and manipulate 3D models.
0:02: Geometry types introduction
0:14: Polylines
0:39: Control Point Curves
0:52: Circles
1:06: Rectangles
1:31: Explode
2:02: Join
2:31: Move
2:52: Extrude curve
3:40: Cap
4:23: Control Points on curves
5:03: Convert extrusions
5:55: Subsurface selection
7:11: Modifying control points for single surface solids
7:53: Deforming solids
8:19: Planar Surface
8:52: Trim
9:22: Duplicate border
9:47: Loft
10:00: Extracting curves from solids
Keywords: Rhino 3d, tutorial, introduction, beginner's course, CAD, computer-aided design, modeling, getting started, McNeel.
Негізгі бет Rhino Beginner’s Course, Part 2: Creating Basic Geometry
Пікірлер