This dude gives more raw information in 7 minutes than some other channels do in an hour. I trust every word Capt. Wayne says.
@markalfresco
4 ай бұрын
Hi. Wish i watched this last year before my masters fell! Hes so right about checking everything ❤
@TheBlackstag1
6 жыл бұрын
hey ocean navigator magazine many thanks for your help ,i just bought a nice 31 footer and are going over a lot of stuff your a great help
@allynonderdonk7577
8 жыл бұрын
Super helpful videos, I wish I had found them sooner!
@oceannavigatormag
8 жыл бұрын
Thanks glad they can be of help
@richardneve1132
7 жыл бұрын
Wayne is also an excellent marine surveyor.
@abdulkkhan5095
2 жыл бұрын
Very important to do, thnx Much.
@radioguy1620
7 жыл бұрын
might want to add check cotter pins for injury hazard, most often thing Ive found,
@martyspargur5281
6 жыл бұрын
radioguy1620 i don't know why some riggers insist on sharp cotter pins sticking out ready to rip someone open. It's not that difficult to remove cotter pins that have their ends clover leafed back into the turnbuckles. Whenever possible, i lock turnbuckles with a #6 round head machine screw in place of each cotter pin, with a nylock. After they're tight, break off the extra screw length and file smooth. Sometimes a fender washer under the head of the locking screw and another one under the locknut makes them sit better.
@hermannbose7347
6 жыл бұрын
I would not consider any of those stays tight ...
@esling77
4 жыл бұрын
Ty
@honeybees1
7 жыл бұрын
Thanks.
@markthomasson5077
Жыл бұрын
Just got a boat with StaLok rigging. Looks ok but is a few years old. I am wondering if I unscrewed the fitting can I inspect the wires inside, then refit, without damage?
Пікірлер: 14