Pretty good and tight for a power plane thanks for the tip I listen and can use it...
@ronbo422
6 жыл бұрын
Spot on, Chris. Thanks for sharing. 😊
@RagTheNutsOff
6 жыл бұрын
Howdy Chris, I’ve not tried this before. I bet that comes out super smooth on the top, Matt
@ShawnG_FPV
6 жыл бұрын
Cant wait to utilize this method on the Vollocity! :)
@DaynHolz
6 жыл бұрын
Thx for all the hints, Chris. But I feel a little sick after watching...because of the very nervous and shaky cameraman. Don´t let him drink so much coffee ;)
@MichaelRyannz
6 жыл бұрын
Chris can you put a link to that tape on Amazon please as well as some other build products.. get yourself a commission from sales as well. Also put up some of those 3D printed parts for camera's etc on your web site or Amazon - you could target the new breed of Micro cameras plus you want team those up with the Runcam Split Mini... as one option.. Cheers Mike
@TheRitewing1
6 жыл бұрын
Michael Ryan hey buddy I put it up in that thread
@cloudburnfpv3626
2 жыл бұрын
Is there a template available to trim the elevens to shape like the ones in the video?
@markballenger513
3 жыл бұрын
z himge
@cloudburnfpv3626
2 жыл бұрын
Do you always have to round the bottom edge of the elevon? Is this just for elevons that are hanging lower than the airfoil?
@TheRitewing1
2 жыл бұрын
If it needs it, it will let you fly with best performance. If it's hanging below you get unwanted control input at certain angles of attack
@cloudburnfpv3626
2 жыл бұрын
Thank you
@conormathews1991
3 жыл бұрын
Skip to 3:47 for the part about z hinge
@bryancrowder6956
2 жыл бұрын
is this a hinge video or LED/motor mount video? too much babble!
Пікірлер: 15