This car didn't need an entire rocker panel replacement, only a small section at the front including the front fender mount. Patch panels for this car aren't available so I'm showing how to fabricate and install a patch to repair this typical rust occurrence.
I used "satin coat" 18 gauge steel but bare steel will work just as well. Tools used should be as you see in the video... cutting, grinding and sanding discs on an angle grinder, cutting and sanding discs on a die grinder, various hammers, a vise, steel scraps, clamps, MIG welder, MAP gas torch, jack and safety stands.
Standard disclaimer here about personal protective equipment and safe working methods.
Comments are welcome. Feel free to ask about particular details that I may not have caught in the video.
Негізгі бет Rocker panel rust repair: fabricate and install patch
Пікірлер: 42