A new version of PxF_VectorEdgeBlur makes adjusting the edge much easier compared to the method shown in this video. More details here:
• PxF_VectorEdgeBlur 2.0
Where should you put the roto edge when there's motion blur? Inside? Outside? In the middle?
Also, what is the proper way to edge extend when the background is polluting the transparent edges?
This video is a reply to Carlos at RTC Roto Labs. Check his video here:
• RTC Roto Labs EP03: Ha...
LinkedIn poll/thread that started this whole discussion:
www.linkedin.com/posts/carlos...
Video by cottonbro studio from Pexels:
www.pexels.com/video/low-angl...
I'm using frames 110 to 162, downscaled to 2k.
00:00 - Intro
00:10 - Hard Edge vs. Middle Edge
02:50 - Corrupted edges
03:30 - Doing roto in the 'middle' on a real clip
04:56 - Only doing key poses is not enough
05:29 - The 'middle' is hard to see!
08:27 - Can you roto better than me?
09:06 - Turning on motion blur
10:49 - Edge Extend
14:34 - Edge Extend vs InPaint (both fail!)
16:50 - Hard Matte needs precision
17:33 - Overlay doesn't line up
18:27 - Prev/next keys are messing the current key!
19:37 - 'Gamma down' is killing antialiasing
20:41 - PxF_VectorEdgeBlur
21:53 - VectorBlur doesn't match the plate
22:55 - Fixing the problem
26:45 - Edge Extend vs PxF_VectorEdgeBlur
27:19 - Why render roto with moblur then?
28:22 - Conclusion
Негізгі бет Фильм және анимация Roto - Where do you put the edge!?
Пікірлер: 29