My pleasure. Our RV Remodeling starts tonight at 8pm eastern! Should have plenty more coming this season!
@agfa663
4 ай бұрын
I would have put a layer of 3/4" butyl tape underneath the flange then dropped the fan in the hole. If ever your self leveling sealant cracks, the butyl will be your backup protection.
@mcstiggens
7 ай бұрын
Couldn't help thinking at the very end, when you whipped out the multi-tool; that would be a great tool to use (with the flat/toothless blade of course) to remove the lap sealant. Great install video. Thanks.
@InterstateAdventures
7 ай бұрын
I had that very same thought after i climbed back down off the roof 😄
@MrNotenoughtime
3 ай бұрын
Great video, thanks for sharing it!
@scotteppers
2 жыл бұрын
Thank you sir.. nicely done. Straight forward.
@InterstateAdventures
2 жыл бұрын
My pleasure, i hate how to videos that take 20 minutes to give a family history and tour of the shop, I prefer straight to it.
@Outdoor-Adventures
Жыл бұрын
Did all the screws from the top outside of the vent line up or you have to drilled new holes? Thanks
@InterstateAdventures
Жыл бұрын
Not all of them no, but the sealant works great and havent had a single leak. Just be generous with it
@fullyard1980
4 ай бұрын
Is your camper a 2008 keystone hornet? I need to replace my bathroom vent too and forgot to measure it when I was at the camper. Lol. So I'm going to wing it snd buy a 14" vent fan. *fingers crossed"
@TomFORourke
8 ай бұрын
Nice job. Look s simple
@InterstateAdventures
7 ай бұрын
It really wasnt too bad. The hardest part was getting the old outside sealant off
@rogergrimm4911
Жыл бұрын
Where did u get your camera for your phone to run wires
Пікірлер: 15