Hi buddy, hows the bike been since the build? Reliable? Over heating? Done many miles?
@perrycountyposse
9 ай бұрын
Reliability has been great. I haven’t had any issues with the bike. It does run warmer than stock, which is expected, but it’s not anything unmanageable. I have about 8000 miles on the motor so far.
@carolinarider5237
Жыл бұрын
Sounds killer!
@perrycountyposse
Жыл бұрын
Thanks! Really wish the mic on the camera could do it justice.
@carolinarider5237
Жыл бұрын
@@perrycountyposse well when I watch KZitems I'm listening with a great set of headphones. So I'm hearing like I'm standing there, almost anyways 😎🤘
@ThawatchaiSarawong
3 ай бұрын
What fuel do you use?
@perrycountyposse
Ай бұрын
Normally 93 octane or whatever is the highest octane available at the pump.
@revealingtruth3559
Жыл бұрын
I have a Revolution Performance 128 with Stag 4 heads and S&S 540 cam (CVO 117 stock injectors, SE 55 mm throttle body, and stock intake). Dyno was 135hp /149tq. I switched the S&S 540 cam out for the Cycle-rama 540-2. Same shop, same dyno with no other changes. Made 143hp /156tq. The Cycle-rama 540-2 hits harder down low and runs out to about 5800 rpm. Had to rebuild clutch to hold. In my opinion, you will definitely see an improvement!
@perrycountyposse
Жыл бұрын
Those are great results!
@jonathannieves8896
2 жыл бұрын
Looking to buy a 2021 street glide and adding the 131 Harley Davidson crate engine. 20k for bike n $7k for engine....
@perrycountyposse
2 жыл бұрын
You won’t be disappointed!
@RickyG512
2 жыл бұрын
Can we hear a hot idle please? Cold idles usually all sound the same no matter the build and with hardly any chop
@perrycountyposse
2 жыл бұрын
I’ll record it tomorrow and upload it.
@RickyG512
2 жыл бұрын
@@perrycountyposse thanks buddy
@perrycountyposse
2 жыл бұрын
@@RickyG512 I wasn’t able to get it filmed yesterday. Weather is expected to be crappy the next few days. I’ll try to get it up by the weekend.
@RickyG512
2 жыл бұрын
@@perrycountyposse thanks Prerry, looking forward to it
@perrycountyposse
2 жыл бұрын
@@RickyG512 Video is uploading now.
@brianlion123
2 жыл бұрын
Did you do springs on those heads or.the stock SE heads?
@perrycountyposse
2 жыл бұрын
When I did the S&S Stage 2 kit with the 540 cam I got heavy duty valve springs. I reused those same springs in the SE heads when doing the Stage 4.
Пікірлер: 26