These capacitors contain bleeder resistors inside them so they can bleed down the charge fully in probably a few minutes. So you don't have to leave it in storage for some time, but it's always a good and safe idea to always discharge them before taking them out.
@edgeeffect
10 ай бұрын
Better safe than sorry.
@patrickdurees3025
2 ай бұрын
thats ok as long as the bleed resistor does not go open circuit in which case the capacitor could still hold a charge so as the poster said always treat these as charged untill you are 100% certain they are not
@kingkongkoalabjrn8050
2 жыл бұрын
Short, to the point, and saftety with inn. Very good video thank you, im a electrician but still good to see some safety discharge info gj!
@tangent8305
3 жыл бұрын
Very interested in seeing you put these components to use. You sir have a new sub.
@ImpBoy75
Жыл бұрын
Great video. Precise and to the point!! My kinda channel
@davidfalconer8913
2 ай бұрын
The EHT diode ( connected to the capacitor ) is useful if you have FOUR of these .... you might make a super high voltage bridge rectifier for various tube projects ( note : these contain several diodes , so they CANNOT be tested with a multimeter set to diode test ) ... the magnetron magnets , stuck on your fridge can store your big cooking tools ... or one on the end of a broom handle makes a good tool to pick up spilled steel nails and screws ( suggest screwing on a plastic aerosol lid , to avoid knocks , the magnets are VERY brittle ! ) ......... ( tried - n - tested ) ..... DAVE™🛑
@varoescal
3 жыл бұрын
Great video! Short and to the point!
@nomoreblahblah
6 ай бұрын
I was planning on discarding an old microwave. Then thought, what is salvageable? Wala! your video shows up in my feed. The matrix read my mind. I'll subscribe and watch more of your videos
@TheMagforever1
2 жыл бұрын
Thanks for the video. Very good and informative!
@johnheaton6705
9 ай бұрын
Great video and your 1000th subscriber. All the best from Bradford UK.
@MrPhatNOB
3 жыл бұрын
Nothing better than going on KZitem and finding that good old cavy has uploaded! Only complaint is that video is too short ;p
@andreasdunlap2307
2 жыл бұрын
I bent the metal back and forth like a real man I didn't cut anything
@FrostyFlankz
2 ай бұрын
😂
@andreasdunlap2307
2 жыл бұрын
love the video though
@fercel1963
3 жыл бұрын
How can I use the transformer as a spot welding machine in thevvmostvcheapest material but with quality
@TheElectroBench
3 жыл бұрын
Thanks for watching! I will add your suggestion to the project queue.
Пікірлер: 17