Because of the noise it makes, I think you forgot to take out the transit bolts
@thechannelonabudget3452
3 жыл бұрын
Mine does the same thing. Just take off the transit bolts
@user-xc1hu5ir7j
2 ай бұрын
Samsung direct drive vrt moment😂
@bibeksinghthakuri8273
3 жыл бұрын
Tighten the bolt below the feet of washing machine and keep it leveled .. hope this helps
@ericxxonvf
10 ай бұрын
I see that the part where it holds the drum to spin is not moving so you gotta take the transit bolts out.
@afnanmuhtady4748
2 ай бұрын
It is happening because the rpm is high and the laundry is thick
@Senhiq
3 жыл бұрын
You forgot to take out the transport bolts in the back because the drum is not moving and the machine is going crazy
@20FreeWill
3 жыл бұрын
I dont think its the bolts would be louder than that . Seems like its hitting its resonate frequency lol
@briantaylor8471
Ай бұрын
Your counter weights are broken on one side
@chloekaftan
3 жыл бұрын
Make sure the Transit Bolt is removed, if it was and it still makes that sound then you should call a Technician and ask them to check the Spider Arm of the Stainless steel Drum, in most machines its made of Aluminium but in Samsung Washing Machines its made of Zinc, if you studied anything in school about what dissimilar metals do then you know where im getting at. If not i will give you a hint, your Spider Arm might be corroded to the point of being structurally unsound, and may spontaneously explode during a highspeed cycle. Dont believe me? Then watch the countless videos of Samsung washers blowing up in the last few years. Also do yourself a favor and adjust the Washing Machines feet so that it doesnt rock around in its speed cycle, that excessive vibration can lead to a premature failure. a well aligned washing machine doesnt vibrate much at all.
@chloekaftan
3 жыл бұрын
Edit: Spider Arm Corrosion also happens in Aluminium Spider Arms since its bolted to a stainless steel drum, but the corrosion of Aluminium happens at a much slower rate, hydrochloric acid (bleach) can speed up this process which is why warranties are sometimes voided if bleach is used inside the Washing machine, the best way further slow this process is to use Sodium Percarbonate to prime the surface of the Aluminium with a protective oxide layer, and use Hydrogen Peroxide instead of Hydrochloric Acid for your bleaching needs.
@CapCurt72
3 жыл бұрын
This is absolutely correct i had this same issue with a washer i bought second hand change spider arm and bearings was about 200 bucks but tear down and rebuild is a job if you're solo
@silver23ification
Жыл бұрын
Barrons new washer
@narutouzimaki4224
3 жыл бұрын
Sound like a gun almost
@alexandree6619
3 жыл бұрын
Los resortes que sostienen la tina están mal
@Charliepope712
5 жыл бұрын
U need to take moving boat out of the machine
@ambrishk18
6 жыл бұрын
Did you find out what the noise was ? I have the same problem with my washer and its a samsung washer.
@randeepchahal611
5 жыл бұрын
Mine is doing the same thing now...probably the bearing needs to be replaced
Пікірлер: 21