I'm a first time gun owner and bought a SAR 9. I shot it for the first time today and needed to know how to clean it. Thanks for the video.
@joemamma2647
8 ай бұрын
Should have least lubed and clean the barrel before shooting it.
@kinfolk0347
10 ай бұрын
My sar 9 has worked flawlessly for 2 years now not a single jam or any kind of issue sar 9 is a masterpiece
@haydenanderson122
7 ай бұрын
I’ve had many different handguns but this new SAR 9 I have is legit cheap functional and extremely comfortable. This thing basically points itself
@jimmydcap
2 жыл бұрын
The break down is so easy. I cleaned and oiled my SAR the day i bought it.
@keithgraham9547
2 ай бұрын
Just bought a SAR 9X. Can't budge the take-down tabs. Anybody else have this issue?
@ogibearjoe
2 ай бұрын
@@keithgraham9547 did you pull the trigger? it has to be pushed in. note you dont have to hold the trigger down while pressing down the take down tabs. i find holding the gun with my non dominant hand and pushing down from the top of the barrel with my dominant rather than pulling them down. Once you push down enough you'll see the slide move forward a little bit.
@keithgraham9547
2 ай бұрын
@@ogibearjoe Thanks for the suggestions. Took it to the gun store to see about new sights. Guy there couldn't move the tabs at all. I got them after about 15 minutes that time. Disassembled yesterday, took about four tries. Those tabs are just incredibly stiff. I usually don't mind 3-dot white sights, but I can't pick these up at all. Surprise! They look like Glock sights, but Glock uses a 5mm front sight screw. SAR uses 4mm. The store didn't have a 4mm tool. Up the street to a gunsmith. They thought they could put on a Glock front fiber optic sight. Oops! Couldn't get the factory sight off without heating the slide and destroying the original sight. Might as well order SAR sights then, right? Fiber optic SAR sights $108 plus tax and shipping plus labor. Do $150 to $200 for new sights on a $400 gun. I decided to go the orange nail polish route. BTW, the 19-round mag only holds 16, and I can't disassemble it without destroying the rubber base plate cover. Honestly, while it shoots ... Hmmm... Okay, I'm a little disappointed since it's supposed to be their best pistol. For about the same $$$, I prefer an FNX-9 I bought recently.
@vincentlyckowski9228
2 жыл бұрын
Not gonna go out and say that sar is as good as glock, but I've had my sar for about 2 years. It never jammed, never malfunctioned. I also have an AR15 from elite firearms in SC. that thing did jammed when I used reloaded ammo. I only ran about 300 rounds through my AR. After thousands of rounds through my SAR, that thing held up.
@clayskidtopdrivesaccount248
Жыл бұрын
Ill take sar over glock anyday
@jonathanbolz2449
10 ай бұрын
You're right on there, Glocks be suck 'in @@clayskidtopdrivesaccount248
@dalebell4441
2 жыл бұрын
Thanks for the video i just got one of these guns in didn’t know how take it apart now I do thanks
@rudridz
Жыл бұрын
Yeah same. I've own a couple of 1911's and bm9's and just picked up a sar9, went to clean it and realized I had no idea how to take it apart
@KuroBlackk
8 ай бұрын
The information you provided was perfect thank you
@rodneyobrien4624
2 жыл бұрын
The sar 9 is a awesome gun love mine BUT please upgrade that trigger !!!
@johnbeven9600
2 жыл бұрын
i have one and love it...ultra reliable...use 124 Nato rounds to break it in, as suggested by SAR...then back to 115
@InfluentialScenes
2 жыл бұрын
I used mag tech 9mm 115 grain my first time and it constantly jammed but it did good wit critical defense 115 grain hollow points
@andrewjankowski9650
2 жыл бұрын
I have run about 200 rounds of 124g. How many rounds have you found it needs to break in before 115g can be used? I have thousands of rounds of 115g which is why I am asking.
@InfluentialScenes
2 жыл бұрын
@@andrewjankowski9650 mine just started doing good with any 115g after like 200 rounds with Blazer range ammo at first it constantly jammed
@johnbeven9600
2 жыл бұрын
@@andrewjankowski9650 SAR advised 300, 124 gr. rounds
@Juno_Beach
2 жыл бұрын
Love Our SAR 9 ... Wish I would have known sooner
@MrZlooze
2 жыл бұрын
First class video!
@beverlymichael5830
Жыл бұрын
I just got my sar9x. Can’t wait to go to the range.
@justinfarris1498
5 ай бұрын
Just took my sar 9x to the range I was rather impressed out the target out to shoot the ar15 at 25 yards. Switch to my side arm for the fun of it to see if I could hit the target I was impressed when I put a full into the target even the range master was impressed
@lemonsandlavender
4 ай бұрын
I wish you had a close up of the lubrication of the lower assembly. I couldn't see the parts clearly
@jimchambers7548
Жыл бұрын
I treat guns like all my tools, i clean after each use before putting it away. The next time you need it doesn't matter if its a day or 6mths itll be clean and ready
@tpr299
2 жыл бұрын
I purchased the SAR 9. I like the gun, but mine came with one bad magazine. The magazine body has different dimensions at the top, and the feed lips are longer. It causes the cartridges to nosedive under the feed ramp, and jamb up the slide. I have called, and Emailed SAR USA, and get no response. You only give a one year warranty, and apparently it’s not honored. Glock, FN, and Walther have provided me great service over the years. I guess you get what you pay for.
@leoguy1609
Жыл бұрын
In the owners manually it doesn't say anything about oiling the frame rails, that's because you oiled the slide rail and is unnecessary.
@JDTaylor-z7w
Жыл бұрын
Great video. Thank you.
@justinthomas4442
2 жыл бұрын
Thanks for the great video.
@wilburfistdagash8327
2 ай бұрын
Wait you have two jobs? Did your half secret past and that accent get Kyle to leave? I have a SAR-9 and love it. Love you too Kaya
@weehawker1
2 жыл бұрын
Thanks So Much ! Please show me / us about setting the safety lever. Is it true that it can be improperly set, and damage the weapon? What is the proper method, sequence, to follow when engaging the manual safety on this weapon, Please ? Thank you.
@clayskidtopdrivesaccount248
Жыл бұрын
Get some optics plate for 9x on your website
@AlptheSpearo
9 ай бұрын
Great !
@richardlinares4616
Жыл бұрын
I got first disappoint from Sar USA my brand SAR9T in stainless steel. Looks good works but can not field strip slide from frame like manual say can it well not come off frame. I take down pin come out take down levers so money time drive crazy beside took force slide them down side gun witch came off gun after doing all that slide would come off gun after trigger pull wracking slide back. So now gone have send my brand SAR9T to SAR USA for them fix issue slide not come off frame. What makes mad heard nothing but good reviews on this handgun have even fired shot in my brand new SAR9T is defect brand new factory.
@rodgerm5311
Жыл бұрын
First thing is to learn English, then you can read the manual and understand how to do it.
@tayjones7506
2 жыл бұрын
Good video love sar usa
@gamzee08
2 жыл бұрын
🤘🏼
@keithgraham9547
2 ай бұрын
Just bought a SAR 9X. Can't budge the take-down tabs. Anybody have suggestions or this problem?
@LynyrdSkynyrdFan
2 ай бұрын
Are you holding the trigger in at same time?
@keithgraham9547
2 ай бұрын
@@LynyrdSkynyrdFan I'm not HOLDING it in, but the trigger has been pulled. I took it to the store where I bought it to see about changing sights. I had managed to disassemble it to give it a cleaning before first firing, but Zi struggled with it about 90 minutes. The guy at the store couldn't budge the tabs. I got it disassembled after about 15 minutes. They didn't have the right size tool to change the sights. SAR is a 4mm fastner; Glock (which should fit) used a 5mm faster. Off to a gunsmith up the street, we decide try just a new Glock front post. They couldn't get off the front sight unless they heat and destroy it. So if we were going to do that, decided better order SAR sights so we KNOW it would fit. Until I saw the price. Sights $109, sales tax, shipping, undetermined amount of labor to change them. I decided $150-$200 for new sights on a $400 gun was unnecessary at that point...
@keithgraham9547
2 ай бұрын
@@LynyrdSkynyrdFan I'm actually a little disappointed in SAR. The 9X is supposed to be their top-end pistol. Besides the tabs on the slide, ridiculous $$ and effort to change the sights, the included kydex holster isn't great and once you attach the paddle, it won't fit back in the case. The case has no place really to store extra magazines. The kydex magazine holster isn't wonderful, and you need 3 mags (one in the gun, two for the magazine holster). The 19-round magazine won't take but 16 rounds. I'm going to have to disassemble it and see if I can fix it. If the take-down tabs and magazine were ok, and it would take common third-party sights, the other things would be nit-picking. The gun shoots nice, but I kind of expected better.
@LynyrdSkynyrdFan
2 ай бұрын
@@keithgraham9547 I hate to hear that. I just ordered a Sar9 Mette platinum. For $285 I couldn't resist. I'll just put a light on it and put it my nightstand. Sorry you had trouble. I'm disappointed about that
@keithgraham9547
2 ай бұрын
@@LynyrdSkynyrdFan Upside is the gun shots fine. The sights are, uh, usable. I can fix the magazine and order a couple more. It was just expectations after seeing such great reviews, they seemed to have as somewhat under delivered. Frankly, if I could have a mulligan, I'd put the money on the Canik all-metal competition model, or toward an S&W .model 25 or 57. That's not to say I'm totally unhappy with it. It's kind of "I'm not that Interested in a second date..."
@RandyGrayBroadcastProPhoto
2 жыл бұрын
You contaminated the solvent dipping into the cap.
Пікірлер: 46