Basic scaffolding training how safely assemble Layher Allround balcony using cantilever method, without any risk.
1. Preassemble the bridging ledger / reinforced ledger, the base collar
(or standard) and the diagonal brace.
2. Connect the diagonal head to the rosette 2 metres up of the vertical standard.
3. Press the bridging ledger/reinforced ledger outwards and attach the wedge head to the rosette
of the vertical standard.
4. Repeat the process on the opposite side.
5. When fitting the steel decks always remain behind the guardrails.
6. Put steel decks over the transom to fill the bracket bay.
7. Fit vertical standards onto the base collars. There is an increased
risk of falls during this assembly step. We strongly recommend the
use of PPE with attachment to already fitted rearward standards or
ledgers.
8. Fit three-part side protection, comprising handrail, intermediate rail,
lift-off preventer and toe board. Knock in the wedges
NOTE
Diagonal braces should be fitted whenever possible to the outside.
This supports the use of horizontal advance guardrails and makes
assembly of the work level easier. The risk of inadvertent knocking
out of the wedge is also reduced.
Verify in each case that the scaffolding structure has sufficient
load-bearing capacity. If necessary, the main scaffolding must be
ballasted and constructed pull-resistant. Information on the load-bearing capacity of vertical diagonal braces can be found in the Allround
approvals or in Layher Allround technical brochure. Fitting of multiple-bay
projections is possible. Projections require sufficiently stable main scaffolding. Only fit and remove scaffolding decks from a secured position.
Негізгі бет Scaffolding training instruction how safely assemble Layher allround balcony using cantilever method
Пікірлер: 5