Dude, thank you. Simple and to the point. I figure with a swivel socket maybe even easier. Some of the other videos of ppl compressing the springs and stuff....SMH. thank you again
@tobygillis4189
Жыл бұрын
Uh...what springs were they compressing?
@edwinquinones1184
10 ай бұрын
@@tobygillis4189 maybe he means use a c-clamp to compress the brake cylinder for reassembly? not sure what other springs there could be...
@wideopenwounds
Жыл бұрын
You’re a life saver.
@jeffreyweir9650
9 ай бұрын
Going to be doing this soon thanks for saving me a couple of hours and not needing to remove the axle and all suspension components 🎉🎉🎉🎉
@jeffreyweir9650
9 ай бұрын
Have one on the rear too? 😂
@zeache4564
Жыл бұрын
Thanks for the video man, today I'm doing this! 👍🏽
@pyramidion5911
11 ай бұрын
👍👍 Great work bud I can tell someone taught you well
@CiGaRRo65
2 жыл бұрын
I have watched some other videos and they seem to make it very difficult, but your make him look so easy that I would try to do it on my Scion Xb, thanks for sharing.
@eltwentyone9398
2 жыл бұрын
youre welcome bud!
@jp7489
Жыл бұрын
Thanks for the vid time to change my out on my 2012 XB👍
@KOTKREW1
Жыл бұрын
This video helped me out best one out that shows the right wayyy thank you ...
@edwinquinones1184
10 ай бұрын
thank you for the video. Torque specs would be nice but thanks.
@Amarillobymorning777
Жыл бұрын
Needs a new drive shaft boot . GR8 video clip
@rayrehkop7606
Жыл бұрын
Thanks man
@allenmartinez8384
Жыл бұрын
Does the star bolt in the middle of the hub need to be removed?
@matthewthomas9872
Жыл бұрын
Yes it does
@matthewthomas9872
Жыл бұрын
30mm 12 point
@Amarillobymorning777
Жыл бұрын
Looks like A piece of cake
@jlo5470
4 ай бұрын
You’re stripping your bolt heads with those 12 pt wrenches and sockets
@jlo5470
4 ай бұрын
I’m sure it won’t be that easy if you live in the Midwest or east coast but with rust.
@hmglor
2 жыл бұрын
Whered u buy your wheel bearing from?
@eltwentyone9398
2 жыл бұрын
you can find them on Ebay,amazon or autozone
@louisroy682
Жыл бұрын
Got it, I missed it, nice job!
@louisroy682
Жыл бұрын
Did anybody see him re-install the center nut for the shaft?
Пікірлер: 25