Hope this helps Nicole, let me know if you need any more help. Key points to remember when changing gullet plates to prevent stripping the head.
1/ Have a tight fitting 4mm Alan key
2/ Insert the Alan key fulling into the head and which will have it at 90 degrees to the screw.
3/ Lefty loose and righty tight when turning the screw. If you over tighten it can damage the nut-saddle connection. So it's very important to go the correct direction and not to over tighten.
4/ When removing the felt to make room for the multi-grips cut toward the screw so not to cut the leather. Once one side of the felt ring is cut use the multi grips to lever the felt away from its bed.
5/ lock the multi-grips around the head and undo. Going to the left!!!!!
4/ Remember to use a medium (normally blue) strength locktite on the screws when putting them back in to prevent them coming loose in the future.
Негізгі бет Screwed the screw? How to prevent & fix a damaged head on the panel screw and gullet plate screws.
Пікірлер