Thank you for the comment. I thought the laser worked very well.
@samsungw200
2 ай бұрын
@baronleathercraft I ordered one and their warehouse flooded...shame I got a good deal lol oh well keep on looking
@baronleathercraft
2 ай бұрын
@@samsungw200 That is lame, sorry to hear that. Lets us know what you end up getting. Thank you!
@samsungw200
2 ай бұрын
@baronleathercraft just ordered the sculpfun s9 it was only 215 quid I thought on it and decided for a bigger cutting area.
@baronleathercraft
2 ай бұрын
@@samsungw200 Nice, that's the 5 watt. it has a .06 spot size so it will engrave in nice detail. It won't be the fastest machine but I always choose quality over speed. Enjoy!
@talesfromthedarkside9583
Күн бұрын
Did you use lightburn for engineering or system software they give you
@baronleathercraft
Күн бұрын
I do all engraving and cutting with lightburn.
@talesfromthedarkside9583
Күн бұрын
@@baronleathercraft I got an one but been using lightburn for for graphics it does great but having problems with engraving slate on pictures it still doesn't turn out as vibrant. Everyone else else's does. I don't know what I'm doing wrong still kinda need to the laser engraving.
@baronleathercraft
Күн бұрын
@@talesfromthedarkside9583 hehe, I am making slate coasters right now. The trick is to adjust your image. I invert and I set mine to jarvis. I take my gamma down so the image is pretty dark also I set my enhance radius to about 15 and then play with the enhance amount and then preview your image. Remember the laser only knows black and white so you want there to be some contrast, but you might not need to adjust the contrast.
@talesfromthedarkside9583
Күн бұрын
@@baronleathercraft ok sorry for all the questions I just have one more the dpi setting I have read that 0.08mm is the laser spot size and it gives me a round 317 dpi because of laser dot size is that the highest I would be able to go
@baronleathercraft
Күн бұрын
@@talesfromthedarkside9583 I do not mind the questions. A higher DPI is useful for designs where fine detail matters, but on simpler patterns, you may not notice much of a difference beyond engraving time. 317, That actually is what I use. I keep it over 300 and I have been using 317 myself. Engraving at a very high DPI (above 500, for example) may not always result in noticeable improvements due to the material's inherent roughness. A laser can only engrave as finely as the material allows, so going too high could lead to unnecessary engraving time without better results. You can always test it and make 2 of the same coaster and crank up the dpi for one of them.
@brentburnett2083
3 ай бұрын
I have a atomstack a5 pro and it feels like it hitting pot wholes and it on my y axis
@baronleathercraft
3 ай бұрын
Does this happen when you push it by hand or just when you do it with the power of the motors? IS this something that just started happening or was it always like this?
Пікірлер: 18