This is a Seadoo 951 DI engine. I have the oil lines connected to the oil pump. The oil pump is removed from the engine (2 small screws) You may not have a spare oil pump drive (plastic adapter) that I insert into the drill motor (drive is from a Seadoo 787. They are easier to fit in the drill chuck on the drill motor) . NOTE: the Drill Motor must be run in reverse because that is the direction the oil pump rotates in operation (counterclockwise). The pump must be BLED which calls for the opening up of the bleed fitting on the oil pump. Another NOTE : is that this bleed fitting line must be closed prior to pumping the oil into the lines. (DON'T Tighten the small screw too much.) There is a small copper gasket on the screw to help it seal. Be GENTLE. Also you do not need a syringe like I used but it is just easier for me to control the oil feed as I make the video. I push the syringe to feed more oil to the pump. I have made a mess a few times using this procedure. Good Luck !!
- Күн бұрын
Seadoo Jet Ski 951 DI Oil line Charging Priming
- Рет қаралды 1,319
Пікірлер