I'm about to do this repair after pitch poling my surfski. Ow my bow! I'm wondering what glue you used to reconnect the two halves?
@aberriman1806
Жыл бұрын
What was the glue you put in the seam? Is it just resin?
@ThePaddyCrook
2 жыл бұрын
What kind of glue did you use on the seam? Would just a standard resin work?
@PaddleDogC5
Жыл бұрын
You could just use thickened epoxy
@DerekElliott-qn2kz
Жыл бұрын
What was the sanding disc grit?
@jbrownco
11 ай бұрын
Looking for this answer too
@barbocc
8 жыл бұрын
Hi Brett, what kind of paint is the black one ? ( at the end ) .
@akhenatn
8 жыл бұрын
might be apoxy with black pigment, so they can polish at the end
@barbocc
7 жыл бұрын
Stealth Kayaks thanks
@PaddleDogC5
Жыл бұрын
Black is gel coat thickened
@sailormoon6
7 жыл бұрын
good~!
@PacoRamosKURRICANltd
7 жыл бұрын
Indestructible 💪💪💪
@Harve955
Жыл бұрын
Rough as guts.
@ItchyDingo
Жыл бұрын
Hahah yeah, I won't be sending mine to sipo, rather fix it myself
@michaeltowler2632
4 ай бұрын
Haha. I'm no tradesman( a butcher) and thought the very same thing. I expected them to spray it and also sand it between coats. They didn't even sand it after the last angle grinder sanding disk chomped into it. Did you notice the other workers in the shed, none had a mask on . They must all believe that fiberglass drops to the ground without any getting airborne.
Пікірлер: 15