Probably others have commented in other videos. Keep the cutting tool overhang to a minimum. Helps avoid vibration. Looking good so far. Really enjoying this series.
@HaveAGoAlan
18 күн бұрын
Thanks, for this particular one I was having to reach over the front of the carriage quite a bit, as the carriage would crash into the faceplate, otherwise :(
@sacriptex5870
Ай бұрын
hehhehe keep going!! One good trick to drill a hole parallell as possible on the drill press, is to rotate the piece as you go to cancel any uneven hole. Greetings from Brazil!
@HaveAGoAlan
Ай бұрын
That's a great tip!
@natthewsmith
Ай бұрын
woo! im here for it
@blazunlimited
Ай бұрын
Second faceplate already! Nice :-)
@a-k-jun-1
Ай бұрын
Castings are coming out way better now. 👍
@HaveAGoAlan
Ай бұрын
Live and learn :) One thing about Gingery, you do a lot of casting work.
@blazunlimited
Ай бұрын
Where did you get the groovy bellows that you used to blow loose sand out of the molds?
@HaveAGoAlan
Ай бұрын
Local hardware store, in their fireplace area. They usually have them, check by their charcoal barbeques if not.
Пікірлер: 10