Question, I recently had all three batteries replaced and now can’t get the hourly beep enabled. The watch repair guy didn’t know how to get the beeping back. Thanks
@plasticindices3385
5 ай бұрын
Hi Friend. That is strange I really dont know. Try pressing all 4 buttons together and rebooting.
@davebrune4001
Жыл бұрын
I never used it because the battery 🔋 drained much faster..thanks for sharing..😎👍
@gggboy77
7 ай бұрын
Thank you I have one aqualand doing that
@plasticindices3385
7 ай бұрын
thanks for watching friend
@alexb8670
Жыл бұрын
How are bezels attached to the case on these 1st generation aqualands? Is it with metal spring or rubber gasket? Thanks
@plasticindices3385
Жыл бұрын
Hi friend, unlike seiko divers, these aqua gen 1 models do not carry any rubber seals along the inner edge of the bezel. Thanks for watching
@josephstuart4440
Жыл бұрын
Hi mate. I have just acquired a beautiful c022 and I love it. However the setting button does not work properly. It’s pushes and decompresses ok, but the funtion does not. Any idea why?
@plasticindices3385
Жыл бұрын
Hi. This problem happens when the copper layer on the electronic plate either wears out or is dirty. If it is the former, then you must apply a little solder in that area. Hope this helps
@josephstuart4440
Жыл бұрын
@@plasticindices3385 are you able to do a video explaining this? Thanks mate
@plasticindices3385
Жыл бұрын
@@josephstuart4440 good idea let me try 👋🏻🙏🏻
@josephstuart4440
Жыл бұрын
@@plasticindices3385 that would be so helpful!!! Thanks from Australia. I also own the JP2000.
@plasticindices3385
Жыл бұрын
@@josephstuart4440 Please check out the last video i put out. I show a circuit plate which was worn out around that area. Thanks for watching! 👋🏻
Пікірлер: 15