Torque Test Channel has done several reviews on SeeSii and they tested very well on their dyno.
@GarageKing
2 ай бұрын
Yes, that actually one of the reasons I did buy it, and it does work great. I have used it for a number of repairs now and no issues. Thanks for the comment :)
@stefanczechorskidds8435
3 ай бұрын
I think that's a good tool to keep in the car tool kit ; with the lug size socket attached.
@GarageKing
3 ай бұрын
You are right and good thinking. It's not that expensive, and could sure come in handy, thats for sure. Appreciate the comment and hope you had a good weekend
@Sioreji
3 ай бұрын
Very nice repair step by step!
@GarageKing
3 ай бұрын
Thanks 👍
@thebunz7
9 сағат бұрын
lug nuts are not hard to take off. you can change the tire with the provided bs kit with car. You are blind and have no idea of the concepts at hand
@GarageKing
2 сағат бұрын
You can take any fastener out by hand, that's why they make ratchets and breaker bars, but this is a common tool used to change over tires because it saves time. If you are changing many tires per day you don't want to look around for the included kit and do them all by hand.
@michaeltammaro482
Ай бұрын
Hmmm. Got mine, exactly the same setup for $129 off of Amazon.
@GarageKing
Ай бұрын
Yup, checked the link, its 139 now so maybe it went up $10? It did well on the torque test channel and that's why I got it. Used it today on my VW : )
@fasteddie5388
Ай бұрын
I had the one that put out 400 and some ft lbs and it was a complete POS. Sockets barely fit and after a few hard uses it doesn't work for longer than 5 seconds and it just quits. After 20-30 seconds it'll work again but the same thing, only for a few seconds and quits. It's worthless. If you want a cheap reliable brand go with hercules brand from harbor freight.
@GarageKing
Ай бұрын
400 is pretty low, this one was a major improvement. It actually did really well on the torque test channel. That's why I bought it.
@lorrynortheastguy4787
3 ай бұрын
How do you rate that knuckle you used at the end for working in tight spots? I saw them on fleabay but thought with the hammer action they would maybe unreliable, it seemed OK with what you did, I just wondered.
@GarageKing
3 ай бұрын
Hey there, the swivel socket, or knuckle I used is awesome and I have used it for years on many different high torque impacts. It is a Snap On though.....
@lorrynortheastguy4787
3 ай бұрын
@@GarageKing Well I'm from UK we have snap on but the one I saw wasn't, but food for thought, thanks for answering I just assumed being a moving part it would take a beating from the hammering action thanks again for answering
@GarageKing
3 ай бұрын
@@lorrynortheastguy4787 No problem at all, and I know the Snap On ones work well, they are not cheap, but I have never broken one and I use them a lot.
Пікірлер: 16