Wll you do me a favour? I´m a segway dealer and try to build my own batteries. Everything seems to be perfect but the battery doesnt´work. A red light is shown so that is bad. My question is: do BMS need being reset for a new rebuild? I´m desperate. I can´t my batteries work. Thank you
@rostravelventure
6 жыл бұрын
What about the gen 1 battery? Can they be revived too?
@Lightillusionsstudios
3 жыл бұрын
are the lithium and nickel batteries interchangeable? my segway had been sitting in my garage for 16 years and have only uses it 6 or 8 times in the beginning ... do you think there is any hope for the? and what does your service cost?
@jkpinpdx
5 жыл бұрын
Where would you recommend this service in the US?
@ronedwards6626
3 жыл бұрын
Hi I live in Tasmania Australia. Were can i buy the equipment to fix the batteries. What would it cost
@fidelhabla7419
6 жыл бұрын
I have a question pls a two red light indecate when i charge my segway it means the battery totaly damage
@cannwoodssegwayplymouth3428
6 жыл бұрын
Fidel Habla hi there , yes good question, yes that would indicate there is a problem with both batteries, could be just it’s been left off charge for a while , it’s very rare in my experience for both batteries to just failed at the same time, unless there’s been water damage or the UIC has gone wrong. Best thing to do is put a voltage multi-meter and check the voltage anything under 43v the segway won’t recognise a batteries attached. Hope this helps
@hamiltonmongalo7756
5 жыл бұрын
hola me puede ayuda no enciende me segway y no me da power con el infokey
@ReneMitt
3 жыл бұрын
Hi! Is there such service in EU? I am in Estonia, but I could ship battery inside EU. Thank you
@tinoglezz7179
3 жыл бұрын
Hola como podria hacer que vuelva a encender mis segway X2 un dia costo apagarla y desde ese dia ya no encendio que puedo hacer
@jr.1264
Күн бұрын
@@tinoglezz7179 Tirnes q especificar un poco más. El Segway lleva mucho tiempo sin usarse? Aparece la antenista en la pantalla del infokey? Hay algún código de error en el infokey cuando intentas encenderlo ?
@njfpv1678
2 жыл бұрын
Hola tengo un problema,he reemplazado las pilas de mis baterias pero al conectarlas nuevamente me dan 2 errores distintos,un error dice baja tension de la bateria y es imposible porque me da el voltaje correcto en la bateria,pero el sedway me dice eso,el otro error dice fallo en placa madre,osea el bms de la bateria,podrias decirme que solucion hay o si hay algun metodo de reiniciar las baterias.
@jr.1264
Күн бұрын
@@njfpv1678 que código de error te da ? El E042?
@MaximusPanin
3 жыл бұрын
And such a battery will not fit 72v 20Ah LiFePO4 (38120 Cells) ? Specification: 1. Nominal Voltage:72Volts. 2. Dimension: 50-100A: 210x240x310mm,30-60A: 360X155X248mm 3. Capacity: 20Ah. 4. Overvoltage Protection: 87.6Volts. 5. Undervoltage Protection: 48Volts. 6. Lifecycle: 2000Cycles. 7. Weight: 17Kg. 8. Chemical: LiFePO4.
Пікірлер: 22