Should’ve put some anti seize on before the yoke.. Good Video
@narekhart9862
Жыл бұрын
Theres always one fag talking about anti seize lmao
@ricknieto9522
4 ай бұрын
😢😢thy
@montymartin4493
5 ай бұрын
I always mark mine with a punch. It wont be out of time
@LightSpirit24
Жыл бұрын
For goodness sakes, use a block of wood to hit the yoke. Every strike had me cringing. One wrong strike and the center threaded spindle would be buggered up.
@narekhart9862
Жыл бұрын
Great video sir thank you
@vicpetrishak7705
Жыл бұрын
Please use safety glasses when air hammering the hard surface . 115/23
@celso8325
9 ай бұрын
Putting it back on is the easy part smdh.
@Vater1
3 ай бұрын
Every time someone uses I torch I immediately rule myself out.
@elviscastillo5437
2 жыл бұрын
I think i got this problem left my truck in a shop in alabsms but my question is what are the symptons when this piece is damaged? Regards and respect.
@HoneyRiverRanch
2 жыл бұрын
Drive shaft spins into power divider and truck goes nowhere
@HoneyRiverRanch
2 жыл бұрын
Sometimes you can lock the power divider in and get it to drive off the back rear end sometimes you can’t
@tedcg20021
Жыл бұрын
by the way how's the socket size to remove the big nut? .thanks!
@KRuslan1000
Жыл бұрын
Socket- 1-5/8
@avandrosgulata9589
2 жыл бұрын
What the nut size
@franchescaready7075
2 жыл бұрын
What’s the Part number for that bearing ?
@joeybenton8986
3 жыл бұрын
You were doing good until you mucked up the nut a new nut and washer 12 bucks but you done to repair right.🤫🤫👌
@HoneyRiverRanch
3 жыл бұрын
70 miles from this shop to parts store we gotta make due from time to time
@endtimeawakening5557
6 ай бұрын
@@HoneyRiverRanch Exactly! When the parts store isn't around the corner, you have to use wisdom. Exercise some of that good old God-given common sense. ❤
@DieselTrucker2018
3 жыл бұрын
I took my 2016 International Lonestar into Petro of Deming NM today and they told me it would take 5 to 6 hours to change the carrier bearing and cost me almost $900!! I think this is a RIP-OFF!! Yes??
@HoneyRiverRanch
3 жыл бұрын
Yeah but that’s how repairs on the road go
@christopheryoung826
2 жыл бұрын
I've never had one take me more than 3 hours, and that was more due to ujoint issues. No way would it take 5 hours to replace a carrier bearing.
@TheAhuizar1990
6 ай бұрын
I got my coolant reservoir, carrier bearing, tensioner pulley, and water pump replaced for $437 . Your definitely getting ripped off
Пікірлер: 24