In this video I go through the thought process for creating the sensors for my uncollapsible paraglider project.
I attached strain gauges on the maillons. This means that as the lines pull the maillons they get stressed and as this happens they get stretched slightly.
The strain gauges will stretch with the maillon and this causes the resistance of the strain gauge to change slightly.
In my next video I'll try to build a system that can read this change in resistance to calculate the tension on the maillons.
Thank you to Sheffield University for all the support
www.sheffield.ac.uk/
And to Aerofix for the maillons
www.aerofix.co.uk/
Support my work on Patreon
/ bandarra
Facebook
facebook.com/bandarra.andre
Instagram
instagram.com/andre_bandarra
== Gear I use for these videos ==
(support me by using the amazon links at no extra cost to you)
Panasonic G80
amzn.to/2Cx4vxd
Panasonic 12-60mm f3.5 lens
amzn.to/2CJh9qB
Panasonic 45-200mm f4.0 lens
amzn.to/2CztH6i
Manfrotto 190Go tripod
amzn.to/2CAuEwf
Mandrotto fluid head MVH500AH
amzn.to/2lQyplN
Rode VideoMicro
amzn.to/2x3Atut
DJI Osmo X3
amzn.to/2fVVTDR
DJI Osmo extra Battery
amzn.to/2xIJgUE
SanDisk Extreme 64Gb micro Sd card
amzn.to/2xIUDMi
Windshield for Rode VideoMicro
amzn.to/2xMEyXg
Smallrig Ballhead Arm V4
amzn.to/2x2VHxl
Osmo Remote Extension
amzn.to/2fYimAn
Movo PM10 lavalier mic
amzn.to/2x2Z4nN
Негізгі бет Sensors - Uncollapsible Paraglider Part 2 - BANDARRA
No video
Пікірлер: 35