Cool video dude, thanks. I like your jig. Bit of advice: Apply your iron across the joint when desoldering, rather than pushing the tip against it, as you did in your second attempt on the first joint. That’s why it didn’t melt quickly. If you preflux it can also help. It’s also worth mentioning braid here as it’s especially effective at drawing solder away from pads like this. ‘Suckers’ are more aggressive, and better suited to through holes and vias. You may want to try flux impregnated solder if you haven’t already, and a smaller gauge solder wire.
@lylebailey-sq2ek
6 жыл бұрын
anyway to cut one stip in half? need only 1.5 strip due to length contrictions
@ryanmilton2643
7 жыл бұрын
I doubt know what that too is you use to remove the solder. need a close-up
@MichaelNolhan
4 жыл бұрын
Definitely more than 400. At that you won’t get anywhere. This also has a heavy flux applied.
@MichaelNolhan
4 жыл бұрын
I will say though that you must be more careful when going up bc the plastic and copper doesn’t have as high a melting point. I imagine the UK and US versions are different to this extent. My solder didn’t do anything til around 600 and holding for almost 2 min.
Пікірлер: 5