This is primarily for those wanting to install larger ESCs and/or longer motors, which could require moving the servo. THere are a few other videos out there showing you how to do this, either using Zip-ties, or a custom-fabricated servo mount. The purpose of this video is to show you how it can be done using a readily-available servo mount (in this case, the RC10B6.2 FT Servo Mount Set, part 91890, from Team Associated), and very few modifications.
Additional parts needed are: two M3x10mm Flathead screws, two M3 Nylock nuts, four servo mount screws (I used the ProTek PTK-3041), and a shorter turnbuckle (you will need to determine the needed length, which is dependent on where, specifically, the servo is mounted...possible lengths are in the 45-50mm length).
Tools needed: 3mm drill bit, countersink. I also recommend using a thinner (I used 1/16") drill bit, to create a starting point, and 'guide', for the 3mm bit.
Негізгі бет Servo Relocation for the Rlaarlo AK 917
Пікірлер: 8