you can just open it up and spin it to the single hash line and then grab the valve if the valve is tight you are 180 degrees out turn it again once around and feel for a loose valve. Then you are lined up
@usethenoodle
9 ай бұрын
Yep. I was just illustrating the factory service manual steps as written. People seem to like the factory service manual procedures. Yes you are correct. When at TDC, the valve rockers will be loose as the valves are both shut tight. Also all valve adjustments are performed on cold engines. Thanks for the comment and for watching!
@not1au
3 жыл бұрын
I have a 2021 XT 250 and about to do the 600 mile valve clearance check. Is there any gaskets I might need to replace after doing it?
@usethenoodle
3 жыл бұрын
No. They are all O-Rings. Mine is an 09 and they were all good.
@not1au
3 жыл бұрын
@@usethenoodle Thanks for the information
@alexstrobeck3367
3 ай бұрын
Thank you so much for this. I’ve got a 600 tenere 55W, do you know if I need to empty the oil before opening it up like this? Havn’t got a workshop so don’t want a flood around the apartments.. Thank you!!
@usethenoodle
3 ай бұрын
Sorry I sure don’t.
@TheodoreAndor
9 ай бұрын
What mark? Sorry you did not show
@pablocalderin3228
2 жыл бұрын
If the timing chain mark isnt lined up do you have to adjust the timing chain? If so can you do it right there or does it require more disassembly?
@xxMadSkillzz
9 ай бұрын
If the chain isnt lined up do another rotation on the crank shaft,
@mapache_del_sur
25 күн бұрын
@@xxMadSkillzzthanks for this comment, because it was exactly what I needed to know. Much appreciated.
Пікірлер: 11