THANK YOU. I'M READY TO BUY A STATION AND START TO WORK.
@josuemulowenu3481
6 ай бұрын
Thanks so much
@RTKVN-VN
2 жыл бұрын
Good job!!
@johnng5107
6 жыл бұрын
Is it possible to convert a single GPS COORDINATES to local coordinates using the data collector?
@LeicaGeosystemsCH
6 жыл бұрын
All GNSS surveyed points are always stored as WGS 1984 geodetic coordinates regardless of the coordinate system being used. Using a different coordinate system converts the coordinates displayed on the panel.
@Auxik
2 жыл бұрын
I just want to set hz to 0 to use it for turning 90s and I can't figure it out for the life of me. There's no "set 0" anywhere in the surface options.
@najjismyth7464
2 жыл бұрын
same issue here.
@johnng5107
6 жыл бұрын
Is it possible to display horizontal distance on the total station while using it remotely with the data collector?
@LeicaGeosystemsCH
6 жыл бұрын
Hi John. Actually, the content is fixed. When shown on the total station, the remote screen contains the current Hz and V angles and the last / currently measured slope distance and cannot be changed to display the horizontal distance.
@johnng5107
6 жыл бұрын
Leica Geosystems AG Thanks for your reply. I greatly appreciate that. Before i was using Leica ts12 total station and i was able to see the horizontal distance on the screen even if i work remotely with the data collector.
Пікірлер: 19