Great video....I have a 1998 Sea Ark 16MVT with a 50hp Etec with tiller tilt/trim and a 4" Atlas Micro jack plate. When the jack plate is call the way up and the boat is trimmed 3.8 seconds the prop is in line with the tunnel. It is a river man's dream boat. I can get to places only people with similar boats su h as MVT, MvJT and surface outboard (mud motors) can get to. I do not have pods on the back not what you have on the back of yours. I bought mine this past May (2023).
@bricehale6593
4 ай бұрын
Thats a really nice boat i want one like it
@TN-Vols-Fan
3 жыл бұрын
Your craftsmanship is amazing. Good job! I've had two G3 tunnel hull boats. Neither one had a relief tube in the tunnel like yours.
@fabricobblegarage9545
3 жыл бұрын
Thanks! The aluminum welding took some getting used to.
@AronStensaa
2 жыл бұрын
Fantastic work!
@fabricobblegarage9545
2 жыл бұрын
Thanks, appropriate it!
@1philliph
3 жыл бұрын
Another way to vent or add air to the tunnel is to put a couple of 1/2 inch tubes in the tunnel that run from just proud of the transom to near the forward edge of the tunnel. If the forward edge detail creates a low pressure zone the air is drawn up the tubes from the transom end. The advantage of is system is that there are no hull penetrations
@motomax13
3 жыл бұрын
very, very clean boat
@fabricobblegarage9545
3 жыл бұрын
Thanks! I tried to keep it as uncluttered as i could.
@tgillilz71
3 ай бұрын
Any way you could share the dimensions on you tunnel length height and width.
@BRG13DEAN
3 жыл бұрын
How did you know how big to make your tunnel? Thinking of adding a tunnel to my 17 River Ox and want to make sure it's big enough to feed a 60 hp motor.
@fabricobblegarage9545
2 жыл бұрын
There’s a formula on outboardjets.com
@ne.laser_jon
5 жыл бұрын
How you lining the set up? I’m thinking of modding my tracker 1448. Bigger motor, tunnel hull and beaver pods
@fabricobblegarage9545
5 жыл бұрын
I loved that setup. I it was well rounded, worked good in deep open water, and could run real shallow if there was a soft bottom. I recently switched to a jet because i started running a lot of shallow rivers with rock bottom. Jet definitely works better for that, but doesn’t work real good on rough water.
@thecubrunkid
3 жыл бұрын
What material is the black switch panel made from on the console?
@fabricobblegarage9545
3 жыл бұрын
just a piece of aluminum
@mattwhalen892
4 жыл бұрын
Can you pressure wash that marine foam out? is it safe on an aluminum boat?
@fabricobblegarage9545
4 жыл бұрын
Are you talking about the mats on the deck?
@hunterroyal1252
4 жыл бұрын
Where did you get that dry box? I have the same boat and am looking for one
@fabricobblegarage9545
4 жыл бұрын
Hunter Royal Not sure where it came from, was in the boat when I got it.
Пікірлер: 26