What angle is the arm when you switched out to put the final angle on the gouge? Is that 45 as well? Using the platform.
@marklengal9990
2 жыл бұрын
This is the exact issue I had over the weekend. Thanks for the tip
@stubrearley9220
7 жыл бұрын
Very good tip Jimmy. It always takes an Englishman to show how it's done! Haha.
@neabud
2 жыл бұрын
And that grinds works amazingly well for that application. Great tip Jimmy. Thank you.
@JimsonMakes
7 жыл бұрын
Great tips Jimmy. Cheers, Jim
@alanbarbour5185
4 жыл бұрын
Thank you for such an informative and easy to understand video. I have been sharpening my chisels without a jig at apprx 45 degrees using a 4" stone and a 2" sanding belt. So far ( touch wood ) they seem to be cutting OK. This little tip will certainly be an addition as and when needed. Many thanks......Alan.
@skiprichardson5834
7 жыл бұрын
Jimmy, I am really enjoying my new Jimmy Clewes 1/4 in. bowl gouge with this short grind. Thanks for sharing your knowledge and your tools. Your demo with the Wilmington Area (North Carolina) Woodturners Association was so much enjoyed by all.
@colmdoyle4542
5 жыл бұрын
Hi jimmy Really like your videos You are helping me as a wood turner to progress Your demos are really detailed and It helps a lot Thanks so much Colm
@stringmanipulator
7 жыл бұрын
Thank you Jimmy, always enjoy and learn much from your videos :)
@raysmith1028
6 жыл бұрын
Thanks so much - wish I had found your Demo's earlier - would have saved hours sanding bruised wood damage.
@RG-ce5hj
2 жыл бұрын
I have been doing spindle turning and started getting into bowl turning. Your videos are immeasurably helpful!
Пікірлер: 15