shouldn't he have measured/tuned from the feed point of the antenna?
@Rooster_Radio
5 жыл бұрын
WinZard a properly tuned antennas tune will not change from the feed point or from the end of the coax
@randyroubal8916
6 жыл бұрын
I have the I-10-K Intercepter 5/8's wave antenna from Jay in the Mojave, looks just like this one and was the first made by Steve! I have had it up for 10 years now and it still has a flat match on it and it withstands the wind really great up here in the Mojave Desert, Frost is no problem either, the antenna still looks brand new & it really hears and talks great. I'm running a RCI 2995 DX CF radio and use the Ameritron AL 1200 Amp & the set up works great.
@flash001USA
3 жыл бұрын
Hopefully you see this message. Let me ask you about the bandwidth. What kind of reasonable bandwidth should you expect above and below the center tuned frequency provided the antenna is in a decent location with little to no obstructions?
@justinruth9729
Жыл бұрын
How would u compare the shockwave to the supper penetrator 500 ..vice versa
@georgebishop2530
3 жыл бұрын
What’s the measurement for top section. Tuning for ch 28 if it makes a difference.
@rogerlawson4516
3 жыл бұрын
Anyone know the db gain on this antenna. Thanks.
@shaneshane-ko8zz
3 жыл бұрын
Are you still selling the shock waves
@WeaponsAcademy
8 жыл бұрын
how broadbanded is it? Can it hold SWR through 11 and 10 meters? I'm looking at this to replace an Imax2000 on 135ft tower. Looks like a beast! How do you think it would measure up against the Imax at that height? Thank you for the videos.....Tim
@Rooster_Radio
8 жыл бұрын
it will tune go across regular 40 and a bit above and below. You would probably need to tune specifically for 10 meters or run a tuner. Performance wise the shockwave like most well made aluminum antennas will outperform an imax, which is basically a piece of wire coated in fiberglass
@aerialheights5680
6 жыл бұрын
52Ω *IS* perfect, 50Ω is merely the industry rounding it down to an easy number.
@dietrichzumwald4777
7 жыл бұрын
What are the measurements of the trombone tuning? How long are they and how wide are they apart? The video is sort of deceiving in the respect. I can't really tell if it's 3inches wide or 4 inches wide and looks to be about 4 feet long or so. Although there are 3 measurements in trombone length, top, middle and bottom. Keep up the good work Rekindling The Reformation !!
@timsmith1029
4 жыл бұрын
You still running this Rooster? What kind of time frame to NY if I buy one? Thanks, 5Zero1 NY 👋👋👋
@Rooster_Radio
4 жыл бұрын
I'd still have one, but I don't sell them anymore. I've heard the wait time is anywhere from 2 weeks to 6 months. Good luck to you.
@outlawhead
7 жыл бұрын
i want to see the full band width ?
@km6hvu622
4 жыл бұрын
Me too.
@jmanranger7271
2 жыл бұрын
Just another ground plane
@Rooster_Radio
2 жыл бұрын
Do you need some attention? That's two comments from you on a video that's several years old
Пікірлер: 19