Oh, how I love the sounds of my Rolleiflex T! Music to my ears.
Here are the notes that I follow when developing my rolls of BW film.
1- Pre-soak
Fill with 68 F water.
Let film sit for a minute.
Pour into drain.
2 - Developer
Agitate film continuously for the first 30 seconds.
Then agitate for 10-15 seconds every 30 seconds.
*The developing times depend on your film and developer you're using.
I use The Massive dev. chart to get the correct developing times.
The film being used: Kodak TMX 100 iso
Developer: Kodak XTOL (stock)
3- Stop Bath
Quickly fill tank with 68 F water.
Empty it, fill again with water. Pour water out.
Pour your stop into tank and agitate continuously for 1 min.
I'm using Ilford Stop so I was able to reuse the stop.
(Pour stop back into container after using.)
4- Fixer
Fill tank with fixer.
(Similar steps as in developer.)
Agitate film continuously for the first 30 seconds.
Then agitate for 10-15 seconds every 30 seconds.
I did this for 7 minutes.
Pour fixer back into container once done.
5 - Fill and empty tank with water about 4 times.
Then take out film from tank and place film in water rinse for 10 minutes.
6 - Photo- Flo
Place reel/film into photo-flo for a minute.
And now you're done!!!
I hope this video was helpful and inspired you to go shoot and/or develop some film!
Next week I'll be making the contact sheet on RC paper. Stay posted!
Thanks again for sharing these film moments with me.
If you want to see more film moments make sure to check out my Instagram.
Find me as @filmphotovm.
#filmphotography #analogphotography #photoshoot #filmcamera #kodaktmx100
Негізгі бет Shooting & Developing a roll of 120 BW kodak TMX 100 ꕥ
No video
Пікірлер: 61