The shutter has some problem in this Makina 67 Plaubel Nikkor 1:2.8 / 80. And there was some almost worn out parts in the part's that actually cock the shutter.
When the arm with the steele wire, that push on the lever on the cocking gear release (or release the film advance arm), the shutter try to fire but couldn't and this was because the lever was not fully cocked because the little aluminium part was a little worn out (I show it the video).
I then make a small part out of a 0.11mm - 0.12mm bronze spring, so I could put the thin plate on to small pin on the cocking gear assembly, and probably make the shutter to work again.
It turn out to be fine and then the shutter is actually working correct again.
Негізгі бет Shutter problem in Makina 67 Plaubel Nikkor 1:2.8 / 80 (Some almost worn out parts
Пікірлер: 21