Basic instructions on how to clean an econobead koi pond filter.
step by step listed below
1. turn of main pump
2. if using flexible pipe for waste connect now if plumbed into a drain ignore this step.
3.close both grey slide valves on bypass pipework
4.turn multiport valve to backwash
5. turn pump on and leave to run for 5 seconds to break up beads
6. pump off and turn multiport valve to rinse
7. close valve inbetween sieve and bead, usually located by pump.
8. place blower into non return valve and turn blower on for around 2-3 minutes to allow all beads to break up properly and release all dirt/debris.
9. turn of blower and turn multiport valve to backwash and open valve between sieve and bead
10. turn on pump and let water run clear out of the waste.
11. when clear turn off pump and move multiport handle back to rinse.
12. turn on pump and let it run untill bead fills to the top and ensure all water coming out of waste is clear.
13. turn of pump and move multiport handle to rinse.
14. open both grey slide valves on bypass pipework and turn pump back on.
15. open air release on top of bead to bleed the system.
16. check over all valves and ensure everything is open and in normal running position.
Негізгі бет Sieve And Bead Cleaning
Пікірлер: 20