Glad to know your still alive and kicking and not dead lol.
@dhorn247
I've been watching your vids for a long time, I'm glad I stumbled across this bc I'm doing this in my 92 right now
@sammybrasch4926
4 жыл бұрын
The tach wire should be a white wire from the pcm. It should directly connect to the cluster and function unless the cluster is from a v6. The tach signal may also be not strong enough to drive the tach. If so, you need a 680 ohm resistor between the tach wire and a switched 12v source
@mikemartin1532
4 жыл бұрын
Love that shop floor
@powershop1903
4 жыл бұрын
Sounds awesome!
@chriskubond6314
4 жыл бұрын
Damn.....that truck is pretty quick
@juanjones4946
3 жыл бұрын
Bra I did laughing when you did the dash and then look over at debo and said what you think 🐕🤣🤣
@braydenmoore2322
4 жыл бұрын
Sounds real good
@jaydeee5961
3 жыл бұрын
Is that a light green and black ?
@diduck6878
3 жыл бұрын
Pin 50 is an output from the ECU for speedo
@mikemartin1532
4 жыл бұрын
Damn u got gas lmao
@shaneriley9244
2 жыл бұрын
What colors go to where?
@georgiaboy1579
4 жыл бұрын
Good job brother! Did you use the connector from the 97 parts truck to hook to the speed sensor on the 92?
@HeadFlowInc
4 жыл бұрын
If your tach has settings for 4cyl, 6 cyl & 8cyl, the tach should work with the LS engine set to 4cyl. 👍
@enriquepena2337
3 жыл бұрын
I got a 95 silverado just made the swap only wire missing is the ones for the original rpm tachometer can help me
@cindicastillo8297
4 жыл бұрын
Hey i just swapped my obs with a 5.3 everything is on now it turns on but when i put it on drive it turns off and when i step on gas losses power any idea wat it could be appreciate it your videos been a big help
@1evilt1
4 жыл бұрын
Pics of the transmission linkage setup?
@HondaBoyGaming
Жыл бұрын
What color was them wires under the hood for the speedometer
Пікірлер: 68