I’m was looking for a good demo/ tutorial to learn how to display my father’s medals, thanks
@nostep2262
2 жыл бұрын
Nicely and very well explained. Thank you.
@ryanmanley441
4 жыл бұрын
A better way is to swing/court mount (depending on what you prefer) the medal onto a medal bar with a brooch pin, much tidier look on the top and no need to feed it through a obvious hole at the top.
@mommyingBetchay
3 ай бұрын
Quite helpful, thank you!!
@Joy-tb1cp
3 жыл бұрын
That looks very nice!
@lindawomack6360
2 жыл бұрын
Good job. Thanks.
@ftsetradersteve2742
Жыл бұрын
Just a couple of observations....Use a scalpel with a 10A blade....Don't bother bevelling the top cut as you cut the bevel off anyway to make the slot wider.....The Sellotape is a bit of a tacky idea if you excuse the pun...What would you do if there was more than one medal...It wouldn't work would it...
@suchitrakesavarapu
3 жыл бұрын
Perfect 👍
@Rohan-nc8jt
4 жыл бұрын
Perfect. Thanks.
@TI-Daddy34
3 жыл бұрын
This works but it requires the removal of the original hardware (needle fastener).
@enmarqueinterlomas8978
4 жыл бұрын
THANK YOU¡ REALLY NICE.
@The_man_himself_67
6 жыл бұрын
Thanks.
@aloysiusjones3985
4 жыл бұрын
I would work from the back of the card so as not to mark the display area. Check the card for square. A fresh blade every time. Acid free tape. A stitch around the gong to stop it moving about. That small ruler makes me squirm.
@Rohan-nc8jt
4 жыл бұрын
Working from the back wouldn't give you a clean cut so messier in the long run & stitching would damage the ribbon.
Пікірлер: 14