One thing I don't understand: don't you have to switch off the "Global Contact" after defining the contact set? And if you apply an axial load on the frictionless (contacts) axle - would'nt it be pushed out of the bearing, causing solidworks to complain about a too big movement...?
@КольоМамата-ш8г
Ай бұрын
Can we just set the global contact to no penetration in this case ? And what will happen if we delete the global bonded contact and let only the local contacts on your case ?
@JeremiahMC100
7 жыл бұрын
How is the shaft constrained axially?
@ickerish
7 жыл бұрын
Would you get similar results if you simply change the defaulted Global Contact "bonded" to "no penetration"? It would save a couple steps here I believe.
@mirmanzarelahi7215
7 жыл бұрын
Although this video is not related to underconstrained bodies but this video helped me to solve problem I was facing from last one week i.e underconstrained bodies (y)
@OnlineStudyLearn
3 жыл бұрын
can you please tell me difference in contact set and component contact in simulation.
@mjice6247
5 жыл бұрын
Save my life. Nice tutorial. Thanks a lot!
@mukreminpolat5295
2 күн бұрын
Thank you verry much 🙏
@gohan100100
11 жыл бұрын
Can you use no penetration feature if you're just in an assembly and not running a simulation study?
@marcantoine2593
7 жыл бұрын
Your video saved my life, thank you!
@yawarhussain972
6 жыл бұрын
sir why u skip the Connection where is it use .......??
@mela9464
8 жыл бұрын
what if you have interferences? what do you do?
@SohilShah_Melodyman
6 жыл бұрын
very well explained......thanks a lot!
@KundathSathish
10 жыл бұрын
Thanks. excellent. To check interference before run and understand contact sets.
Пікірлер: 18