Ça fait 2 fois je tombe sur tes video par hazard, et encore une fois tu me fait sauver beaucoup de temps merci, encore une fois ton anglais est tres bon
@garythrasher2410
2 жыл бұрын
Good job on video's 4700 hard miles on my renegade, and had the old nervous feeling better check it and POW got it apart and both rollers have a crack in them.... pain in the ass avoided thanks!!!
@catdimirpupin468
5 жыл бұрын
I used a 3mm x .5 rolltap with a releif cut that i happened to have in my shop, I threaded it in about 3 threads then the releif grabbed the rollpin slot and started to spin it, i then grabbed the end of the tap with a small pair of vice grips and twisted it back and fourth while pulling and success! got them both out on a 2013 800 etec. thanx for the vid and info! i was well prepared to drill as instructed but thank god i got out clean! thanx again!
@dustyLenscap906
3 жыл бұрын
Thanks for the video! Great information! Thought I'd share I recently did a 2013 roller replacement. I was able to tap the pins with a #4 tap. Threaded in a #4 socket head cap screw and grabbed the head of the screw with a slide hammer that has a vice grip attached to the end of the tool. One action of the slide hammer and the pin pulled right out. I used a small standard tap handle which interfered with the shaft a bit. I ordered a lisle tap socket set for next time. The socket would have allowed for no interference with the shaft while tapping.
@AJ-ik7br
7 ай бұрын
thanks man! just what I needed
@iBackshift
7 жыл бұрын
i added this to my favorites. Great video there bud Joey
@mattpee55
5 жыл бұрын
Really wish I would have watched this before i started. Thanks for the help
@randyphillips2075
5 ай бұрын
I read in a few posts where guys claim the pin is not actually requird and did not replace the it. They just tourque the bolt and used the lock tight. Hence the reason for no hole in the new bolt.
@jean-francoisrousselle7543
2 жыл бұрын
Nice vidéo i change my roller in my 2013 skandic whit the short spring pin whit all your trick.thank you
@jasonholbrook1555
6 жыл бұрын
This seems like craziness!! I have stripped my bolt out and now see what fun I have in store. How can there not be a better system in place from skidoo?
@TheDanoue
3 жыл бұрын
Awesome man thanks for sharing
@rogerwalsberg
4 жыл бұрын
I've worked on a number of different makes and models. I'm amazed at the poor engineering decisions that are made. Of course you can't make everything perfect first time, but us shop guys just shake our heads sometimes. Engineers should be out in the shop taking apart everything they've designed. You'd see a different world.
@thomascombs1399
2 жыл бұрын
How do I find the pin size I have a 2020 Can-Am Ryker 900. Dowel Pin Part# is 420629200. My clutch has holes but there were not any pins there.
@chargerfish1
8 ай бұрын
Why does everyone take the entire jackshaft out? My secondary on my XP just slides right off....
@MikeM-u9x
Ай бұрын
Yours is not stock then. 99.9% of the population has a stock secondary clutch.
Пікірлер: 15