I can't laugh! That's my luck. I know you'll figure it out.....
@392blurredlines
3 жыл бұрын
Yea, I think I got it figured out. I’ll just lower the entire k-member low enough to bypass the rack and pinion. I’ll get the oil pan that I want then.
@Smob109
3 жыл бұрын
So what made you position the motor the way it is. I might have missed that part on your other videos. With the motorplate it seems that you could have set it higher therefore not having to customize the oil pan. I guess you would have to consider the transmission mount/position. Then driveshaft angles. I'm just thinking out loud.
@392blurredlines
3 жыл бұрын
I had to align the center of the crankshaft with the center of the rear end and keep it as level as possible. With a normal k-member I wouldn’t have any issues, but this unit has a rack and pinion setup that is directly under the front of the oil pan. I can lower the K-member a little more for the clearance of the oil pan so I should be ok. 👍🏽
Пікірлер: 5