Snap-On branded 20 Gallon upright air compressor. Replacing a new dual air regulated air manifold after the original had a permanent break by building a new one.
Note: Use caution before disassembling any air lines by ensuring all air is released from tank and compressor is unplugged.
All parts included:
X2 - Husky ¼” Pressure Regulators with Gauge
X1 - ¼”x ¼” x ¼” Brass NPT Female Pipe fitting
X1 - ¼”x ¼” x ¼” x ¼” Brass NPT cross Female pipe fitting
X5 - ¼” Brass Male NPT hex nipple
X2 - ¼” Brass female 90 degree elbow
X2 - ¼” Brass coupling
X2 - ¼” 2 inch brass pipe
X1 - Thread Seal Tape
X1 - bag of cable straps (used two to hold kit on original tank mounts)
Recycled
X1 Main Pressure Gauge, X2 Quick connects, X1 Pressure relief valve
Негізгі бет Snap-On 20 Gallon Air Compressor Manifold Rebuild
No video
Пікірлер: 13