I'm rebuilding one now, i need a piston for it. Do you know how long the piston was.
@ray5961
4 жыл бұрын
shawn I didn't measure it, but the parts diagram should have a part #
@Gustav4
4 жыл бұрын
Hello, I need to find out what the strongest air hammer is on the market for heavy duty, is it this one?
@ray5961
4 жыл бұрын
Gustav I don't know if it's the strongest, but it's very highly regarded and from the research I did, it appears to be up there as far as strength.
@bluntv1
4 жыл бұрын
The best 1 is cp717 shank .498, super power zip gun
@bg1617
8 күн бұрын
When re-installing the quick connect chuck (that holds the bits) do you thread that on dry or apply grease/other lubricant to the threads?
@ray5961
8 күн бұрын
I put a tiny bit of grease, but not much.
@bg1617
7 күн бұрын
@@ray5961 gotcha, thanks. What kind of grease?
@ray5961
7 күн бұрын
@@bg1617 I use this one: www.amazon.com/gp/product/B000XBH9HI/
@jonholt201
3 жыл бұрын
did you hit the outside with a buffing wheel?
@ray5961
3 жыл бұрын
Jon Holt I think so. I don't remember for sure, but that sounds like something I probably would do haha :-)
@chrisleggett685
2 жыл бұрын
Mine is blowing air out of the part where the bit goes in. Any idea why?
@ray5961
2 жыл бұрын
Hey Chris - it's been a while since I worked on mine. Have you taken yours apart to inspect it? Air does vent out, but I can't remember which direction. If you put a bit in, push it down on some wood or something and see if it works. As I remember, you have to press the bit against something to make it function, but I can double check that tomorrow when I'm in the shop if you need me to. Basically everything I know about this particular tool is covered in this video.
@user-hq3ih4en2w
3 ай бұрын
How do i get the whole assembly to slide out? I used pry bars and nothing
@ray5961
3 ай бұрын
man, it's been so long ago, I don't remember.
@nutsackmania
3 жыл бұрын
nice man--marked this video down for future reference
@edhurst8051
Жыл бұрын
I found repair parts at Power Tool Repair Tallmadge OH $15 delivered
@jakefoskett1604
5 ай бұрын
Good to know
@davidhenderson3400
2 жыл бұрын
What about the trigger? My trigger went in and stayed in.
@ray5961
2 жыл бұрын
It's probably just dirty in there. Try spraying some gasoline down into the trigger area and blow out with compressed air. That might free things up.
Пікірлер: 21