I know this is an older video. But, I'd like to make some comments that might help someone. I think these are great little machines. Snapper 3201 with Tecumseh AH600 2-cycle engine. It's at least 30 years old and I think it will run a few more decades. If you have to replace the belt, you need to remove the pulley. I used a 1 inch open end wrench on the flat part at the center of the pulley. It's going to be tight! The manual says use an adjustable wrench. Adj wrench would work as long as it is a quality tool that stays tight on the hub and is big enough to give you some leverage. Pulley loosens clockwise as marked right on the pulley! I also replaced the rubber paddles on the auger. First, I soaked the screws for a few days with oil. All the heads were rounded off and undersized from years of pounding through the snow. Regular wrenches and sockets did not fit. So, I used a 5/16 inch bold extractor. The extractor was able to grab and it was easy work after that. Take the spark plug out while working around the auger. No risk of starting this way.
@small_engine_repair
7 ай бұрын
Thanks for the information!
@atown7714
2 жыл бұрын
I have this model, Think it’s from 1984!!!!
@small_engine_repair
2 жыл бұрын
Possibly
@RepairGang
3 жыл бұрын
it don't snow in the part of Arizona im in so i have not fixed alot of these
@small_engine_repair
3 жыл бұрын
What part of AZ? I grew up in north Phoenix. Moved away in 99 to get away from the heat!!
@RepairGang
3 жыл бұрын
@@small_engine_repair kingman az I'm 3 hours away from phx
@Ala570r
2 жыл бұрын
Said that's is a two cycle but I wish you have minchines how much to put in to per gallon
@small_engine_repair
2 жыл бұрын
Luci the mix depends on the engine manufacture. The manual should say what ratio to use. If you search for "2 cycle mix chart" you will find plenty of information on how much gas to oil.
Пікірлер: 9