This video walks you through adding snowflakes to the base of pixel arches that use ½ inch emt to tie the two bases together. My arch bases were 3D printed using www.SFL-Deigns.com design. Before I started this project I reached out to SFL-Designs for some custom fittings. Jason designed these and has put them on his website for your use. Below lists the parts used in this video. The materials for the construction of the arches are listed in the description of my triple arches video ( • Triple arches .
Materials:
3D printed fittings for EMT and PVC: sfl-designs.com/?store-page=P...
35 mm M4 screws on Amazon: www.amazon.com/Adiyer-40-Pack...
M4 Nuts on Amazon: www.amazon.com/Nuts-M4-0-7-St...
Негізгі бет Snowflake arches
Пікірлер: 8