Nice set of clips. I looked at them and the shafts are insulated with some type of clear coating, so even if they touch they should be okay (other than the very tip of curse).
@alexstone691
3 жыл бұрын
Well, i didn't know this was a thing, three things combined into one, programming electronics and locks
@christelting1359
Жыл бұрын
I wish you would have tested for continuity when they were attached.
@IntradeMotors
3 жыл бұрын
the issue i could see if conformal coating they wont make contact. I got a scraper needle they ground sharp as special tool i got from LSC training to remove conformal coating as trick.
@lambertomidolini8027
3 жыл бұрын
I’ll just use acetone to clean the Conformal coating,(I did the same course years ago through Lsc)
@wattvoltamp
3 жыл бұрын
Small Outline Integrated Circuit
@3dsmaxrocks699
Жыл бұрын
Still not small enough for the chip I'm testing on a Sony portable digital recorder
@mumumumah
3 жыл бұрын
Sounded like Russell Crowe narrating. (In accent and timbre.)
@mrforex9628
3 жыл бұрын
Lol - China will investigate. These are knockoffs of the original E-Z micro pincers. Still good value for this kit.
@renegadecampervan5017
3 жыл бұрын
Looks like we may as well have joined the watchmakers! U lost me at magnifying glass
@tvsettv
8 ай бұрын
Very uncomfortable and unreliable. PC3000 style needles are much better, but more costly
@dazaessox
3 жыл бұрын
think they are rubbish either clip on or remove job done
Пікірлер: 14