Thanks for this walkthrough, as this was a challenging part. I did it mostly the same way you outlined, just not as quickly or efficiently. Ivan's trick of window selecting edges for filleting is brilliant - I can't believe I've been manually clicking on individual edges for the last twenty years like a chump. Definitely one that I am working on incorporating into my workflow.
@TooTallToby
9 ай бұрын
Ivan is a TOTAL LEGEND!
@alborzkooh518
9 ай бұрын
it was really great man thank you
@TooTallToby
9 ай бұрын
Thanks so much! Glad this helped!
@vishank7
9 ай бұрын
Great video! Did the flatten work with the part modeled this way?
@TooTallToby
9 ай бұрын
Thanks! And no, not with sheet metal. So the only way to flatten this one would be to do a surface flatten. Should I make a video for that tool?
@vishank7
9 ай бұрын
@@TooTallToby That would be helpful, thanks Toby!
@amasll
9 ай бұрын
Where is the Flat pattern, if I make sheet metal, I often have to finish with laser cutting and folding 🙂
@TooTallToby
9 ай бұрын
take a look at the livestream TOBYS SHEET METAL TIPS AND TRICKS - that's where I explain how to use flat pattern in solidworks. For this model, I couldn't figure out a good way to do it in sheet metal (and flatten the results) - but I'm open to suggestions!
@vandbaxelrad6902
6 ай бұрын
Hey Toby. Thanks for the continued wealth of information. But... Design is rarely the problem. In real life you need to manufacture the design and in this case it would 100% have to be sheet metal, laser cut and bent. So if you can't flatten it you can't make it. If you can't make it your design becomes irrelevant. To solve this problem I'd design the bracket without the three tabs. Flatten it and add the tabs to the 2D cut file. After laser cut I'd bend the two ends to the correct angle and roll the round part over a mandrell. While on the mandrel, I'd clamp the part in place forcing the ring to stay round and only then bend the three side tabs. Cheers.
@TooTallToby
6 ай бұрын
Good work!@@vandbaxelrad6902
@ciorad1389
9 ай бұрын
I did the tabs, circular pattern, "Body" around an axis, then I modeled the other feature. Dragos
Пікірлер: 15