I’m loving these. I just got Solidworks on the Veterans purchase program, it’s $20! I’ve hopped around different CAM programs over my career as a machinist and I’m liking solidworks CAM. It’s pretty quick to generate useable tool paths. Keep these videos coming!
@DavidYost-qf5tr
Ай бұрын
Professor Cameron, thank you very much for your time and efforts to provide these tutorials. Do you have a tutorial to take this part in this tutorial or any other with Ref G54, vise #1, to the second operation, G55 or vise #2, to face off the bottom and finish with a deburr op? I'm not sure if I'm looking for a 2nd mill oper, a sub routine, or a G52. Essentially, every time I open the door I'm loading a blank and unloading a finished part. Thank you.
@stevennewman3231
8 ай бұрын
I'm loving it as well. Keep up the amazing videos.
@shahadipour
3 жыл бұрын
Thank you great video
@djipreview
Жыл бұрын
My problem is we don't use auto generate features. How do I go without using that feature to say just rough a profile
@yogim9171
3 жыл бұрын
Nice video, continue more videos on each commonds
@beto1989
2 ай бұрын
Im trying to "extract machinable features" and it doesnt extract machinable operations; it stays the same. Any suggestions ?
@qutibaaltwara4009
3 жыл бұрын
Thank you very much for this video. When using the Volu-mill strategy, the feed rate values in the g codes may have decimal places. the problem that the controller of a machine does not accept decimal places. Is there a way so I get just integer feed rate when using Volu-mill.
@stevennewman3231
8 ай бұрын
Love it
@rengankrishnaiyer6912
2 жыл бұрын
Sir, how do you add tabs ?
@haziqsyazani7365
11 ай бұрын
Where was the face mill operation ? In my opinion face mill must be the first operation
Пікірлер: 12