nice idea but for your information usually we do the face mill manually ... great work professor
@teckseongchong
2 жыл бұрын
Thx for nice video
@lancenorthey1282
2 ай бұрын
very good info but unsure why you deleted the second corner clean up rough mill at 19:00 especially when other times you always deleted the contour mills. Was beginning to think contour mills were just glitched and you instantly bin them.
@TheDispo
2 ай бұрын
Thank you very much for the realy good video for beginner. I have maybe a stupid question. My homemade router is equiped with a 2kW spindle where I cannot go under 9000 rpm. (Its written that I can damage the spindle when I do so) This means that I cannot cut most of the material because the minimum speed is too high ?
@georgechambers3197
3 жыл бұрын
I noticed your .25 end mill had a LOC of .75". Will the shank of the end mill rub on the part after the .75" depth? Thanks for the video!
@craigmurray4016
3 жыл бұрын
MORE CAM TUTORIALS WOULDBE GREAT, FROM SKETCH ALL THE WAY TO GENERATING CODE PLEASE
Пікірлер: 8