I already to subscrive in your channel, wash very userful for me, was help me a lot,congratulation for the channel!!
@ModitRC
3 жыл бұрын
Thank you!
@trexinvert
4 жыл бұрын
Has solidworks "fixed the problem" when trimming. That if you have an "enclosed or trapped volume" left over during trim, then the trimming fails with some stupid message about "....manifolds..." I wasted a whole hour sweeping and creating surfaces, and when it finally came to "what should have been" simple mutual trimming it became a nightmare.
@guidetosolidworks3714
4 жыл бұрын
I am not sure if it has been fixed o will have a more of a look into it.
Пікірлер: 8